top of page

Bosch Dishwasher - Not Completing Cycle & Displaying Error Code

Oct 8
1 min read

Model: SHP78CM5N/28

Location: Ave Maria, FL 34142


Repair Summary

Checked dishwasher for not completing the cycle and displaying an E31 error code. Customer provided a photo of the error code, and the tech sheet indicates E31 is related to the water leak sensor being activated. Upon arrival, inspected the drip pan and found it completely dry with no water present. Started a cycle and monitored the dishwasher for more than 10 minutes, checking the water valve, hoses, sump motor, drain motor, inlet, and actuator. Pulled the dishwasher out and inspected the components behind the unit and found no evidence of water leakage on the floor or surrounding areas. Customer also stated they had not observed water on the floor. Opened the dishwasher and found excessive soap suds remaining inside, which could have contributed to the previous issue. Removed and inspected the sump and drain pump assemblies and found no physical damage. Replaced the affected components and educated the customer on proper detergent use, maintenance, and cleaning procedures. Canceled the cycle and verified the dishwasher drains properly through the garbage disposal. Customer also reported an abnormal noise and provided a video; the noise shown was consistent with the drain pump operating during the E31 condition. No abnormal noise was present during today's testing. During testing, water began backing up into the sink, indicating the drain line or household plumbing may not be flowing freely. Advised the customer to have a plumber inspect the plumbing under the sink. Customer will monitor the dishwasher during the next several cycles. Unit checks normal at this time.



 
 
bottom of page