top of page

GE Washer - Not Completing Spin Cycle

Sep 18
1 min read

Model: GUD27ESSM1WW

Location: Immokalee, FL 34142


Repair Summary

Checked washer for not completing the spin cycle. Upon inspection, found the spin basket wobbling. Spent over one hour attempting to remove the agitator, but it was fused to the transmission, preventing further inspection and requiring a complete tub job. Due to the washer being installed in a very tight area with insufficient working space, customer was advised the unit would need to be removed and placed in the living room before the repair could be completed. Returned and completed the tub job; however, during reassembly, the original agitator would not properly seat onto the new shaft and appeared to be separating underneath, requiring replacement. Returned with a new agitator and attempted installation multiple times, but it would not slide completely onto the shaft or seat properly. Compared the replacement agitator with the original and found the shaft opening on the replacement appears noticeably narrower. This is now the second replacement agitator with the same fitment issue, and no visible defect was found with the new shaft. GE will need to be contacted for further technical direction regarding a possible part fitment, design, or manufacturing issue, as ordering the same agitator again is likely to result in the same condition. Repair cannot be properly completed until further direction or alternate resolution is provided by GE.



 
 
bottom of page