top of page

Maytag Washer - Cycle Ending Once It Starts

Nov 6
1 min read

Model: MVW4505MW0

Location: Lehigh Acres, FL 33972


Repair Summary

Checked washer for reported issue of going directly to the Done status shortly after starting a cycle. Upon arrival, inspected the unit and retrieved stored error codes from the main control board indicating that the lid lock was not sending the proper closed confirmation signal. However, during operational and diagnostic testing, verified that the lid lock was engaging and locking correctly. Also noticed that the motor was not operating at full strength. Tilted the washer back for further inspection and discovered that the motor capacitor had fallen onto the floor beneath the unit, with a broken and shorted wire. Determined that the main wiring harness and motor capacitor required replacement.


Removed and replaced the defective motor capacitor and main wiring harness. Reassembled the washer and performed operational testing to verify proper functionality. Confirmed that the motor now operates correctly and the washer starts and runs through its cycles without prematurely advancing to Done. All checks passed, and the washer is operating according to manufacturer specifications at this time. Video documentation attached.



 
 
bottom of page