top of page

Maytag Washer - Not Starting

Oct 12
1 min read

Model: MVW6500MBK0

Location: Cape Coral, FL 33909


Repair Summary

Checked washer for not starting. Upon arrival, attempted to start the washer and found the Sensing light continuously blinking with no error codes displayed. Further testing indicated the main control was not properly detecting the lid lock. Tested the lid lock and measured approximately 74 ohms, which is within the manufacturer's specified range of 50–160 ohms. Customer stated the main control board had been replaced the previous week and the washer operated normally for several cycles afterward. Customer also reported several severe thunderstorms in the area recently. Replaced the lid lock assembly and main control board. Ran diagnostics and completed the calibration cycle. Verified the washer fills, washes, drains, and completes the spin cycle properly with no leaks. Unit checks normal at this time.



 
 
bottom of page