Samsung Dryer - Overheating Issues
Model: DVE55CG7100VA3
Location: Fort Myers, FL 33919
Repair Summary
Checked dryer for customer complaint of overheating and concern that the heating element may be shorted. Upon arrival, started an Air Fluff cycle because previous notes indicated the dryer was producing heat during this cycle. Confirmed the heating element was not energizing during Air Fluff, indicating normal operation. Inspected the exhaust vent and found the flexible vent hose severely crushed behind the dryer, restricting airflow. The exhaust exits directly through the wall behind the unit. Pulled the dryer away from the wall and immediately heard a significant amount of sand and dirt being expelled through the exhaust. Ran a drying cycle and monitored heating and cooling performance. With the dryer pulled away from the wall and proper airflow restored, the heating and cooling cycles operated correctly.
Pushed the dryer back into its installed position and confirmed the restricted exhaust airflow caused the dryer to overheat and prevented it from cooling down properly. Connected the dryer to HASS with the vent restricted and received a CT error code. Pulled the dryer away from the wall again, restoring airflow, and reran HASS diagnostics. The dryer passed all tests with no error codes. Confirmed the overheating condition is caused by the crushed exhaust vent rather than a defective heating element or internal dryer component. Educated customer on the importance of proper exhaust ventilation and advised replacing or modifying the flexible vent system to prevent crushing when the dryer is pushed against the wall. Customer stated they will have the vent system corrected. Dryer operates normally with unrestricted airflow, but the ventilation issue must be resolved before normal use.




