top of page

Whirlpool Washer - Not Completing Cycles

6 days ago
1 min read

Model: MHW8200FW0

Location: Cape Coral, FL 33993


Repair Summary

Checked washer for customer complaint of not completing cycles properly when washing very small or large loads, while medium-sized loads appear to operate normally. Entered service mode and found two stored error codes related to the door lock and water level sensor. Pulled the washer out, removed the top cover, and inspected the water level pressure sensor and hose. Blew through the pressure hose into the tub and confirmed proper airflow with no obstructions. Customer's home operates on well water. Performed service diagnostics on all components and found reduced water flow through one of the inlet valve solenoids due to sediment buildup in the inlet screen. Replaced the water inlet valve assembly and repeated diagnostic testing, confirming significantly improved water flow and pressure. Also verified that the water level pressure sensor was correctly detecting water levels and communicating with the main control board.


Further inspection revealed corrosion around the detergent dispenser housing, along with a minor drip and significant mold and debris accumulation inside the housing. Informed customer of these findings and recommended cleaning the dispenser assembly to maintain proper water flow and prevent additional buildup. The minor drip does not appear to require immediate repair but should be monitored. Completed operational testing and verified that the washer fills, agitates, drains, and spins properly. No active error codes or additional leaks were detected during testing. The improved water flow should help prevent recurring water level errors and incomplete cycles. Unit is operating normally at this time, and customer will continue monitoring performance.



 
 
bottom of page