top of page

Whirlpool Washer - Washing Issues / Stuck In Sensing Cycle

Nov 5
1 min read

Model: WTW4816FW3

Location: Fort Myers, FL 33901


Repair Summary

Checked washer for not washing properly and getting stuck in the sensing cycle. Upon arrival, ran diagnostics and found no stored error codes. All diagnostic tests passed. Ran a Quick Wash cycle while servicing the dryer and verified that the washer filled properly, agitated, drained, and spun without any issues. During inspection, found that the suspension components were beginning to wear and required replacement.


Replaced the suspension components and main control board in accordance with a manufacturer service bulletin. During the repair, while tilting the washer backward, the water supply hose broke at the connection. Documented the incident with photos and video and showed the customer the damaged connection. The washer is installed in a shed with a concrete floor, and no property damage occurred. Attempted to replace the hose but found that it was permanently connected to the wall-mounted water valve, requiring a plumber to complete the repair. Shut off the water supply to the washer and advised the customer to have a plumber repair the wall connection before using the unit.


Completed washer calibration and verified proper operation following the component replacements. Washer checks normal at this time, but the water supply remains shut off pending plumbing repairs. Customer left for work and was unavailable to sign the service ticket.



 
 
bottom of page