top of page

BLOGS


KitchenAid Dishwasher - Door Panel Rusting
Model: KDFM404KPS2 Location: Fort Myers, FL 33913 Repair Summary Checked dishwasher for the outer door panel rusting and corroding. Whirlpool authorized replacement of the outer door panel. Replaced the panel and transferred all necessary components to the new assembly. Reassembled the door and verified it opens and closes properly. Customer reported no additional functional concerns with the dishwasher. Unit checks normal at this time.


Maytag Washer - Off Balance Issues
Model: MVWC565FW1 Location: North Fort Myers, FL 33917 Repair Summary Checked washer for going off balance during every cycle. Ran diagnostics and found two stored error codes related to unbalanced loads. During the spin test, observed the basket contacting the side of the cabinet even with no clothing inside. Inspected the suspension system and confirmed the suspension rods had failed. Replaced all four suspension rods, recalibrated the washer, and ran diagnostics to verify


Frigidaire Fridge - No Cool
Model: FRSS26L3AFD Location: Naples, FL 34113 Repair Summary Checked refrigerator for no cooling. Upon arrival, found the compressor and all fans were not running. Tested the compressor windings and measured approximately 10 ohms across each winding, with the compressor checking normal. Inspected the control board and found the red diagnostic LED continuously flashing, indicating a thermistor-related fault preventing the cooling system from starting. Verified and corrected th


Samsung Range - Light Issues
Model: NSI6DG9550SRAA Location: Fort Myers, FL 33913 Repair Summary Checked range for the upper portion light not working. Upon inspection, found the light socket had shorted while the bulb filament remained intact. Replaced the socket assembly and verified the upper light is now operating properly. Customer also mentioned the cooktop did not seem to be heating properly. Educated the customer on proper use and care, including the requirement to use induction-compatible cookwa


GE Fridge - Weak Water Pressure & Noisy
Model: GSS25GSHGCSS Location: Fort Myers, FL 33913 Repair Summary Checked refrigerator for weak water pressure from the dispenser and a chattering noise during dispensing. Verified good water pressure from the household supply to the refrigerator, confirming the concern was not related to the home plumbing. Found water was not flowing properly through the filter housing. Replaced the filter housing and dispensed several glasses of water to test operation. Verified strong wate


Whirlpool Fridge - Water Filter
Model: WRS321SDHW08 Location: Cape Coral, FL 33904 Repair Summary Customer requested assistance replacing the refrigerator water filter. Shut off the water supply to the refrigerator and replaced the water filter. Restored the water supply and flushed approximately one gallon of water through the dispenser. Cycled the ice maker and verified it harvested the ice from the mold and filled with water properly. Checked all connections and found no leaks. Unit checks normal at this


Whirlpool Range - Front Right Burner Not Working
Model: WFE320M0ES2 Location: Lehigh Acres, FL 33976 Repair Summary Checked range for the front right burner not working. Inspected the burner and found no visible physical damage. Verified the regulator was supplying voltage to the burner. Replaced the burner and confirmed it began heating; however, it would not regulate properly from high to low. Further inspection found the burner regulator burnt and defective; photos attached for documentation. Replaced the regulator and t


GE Dishwasher - Leaking
Model: GDT665SSN4SS Location: Fort Myers, FL 33905 Repair Summary Checked dishwasher for leaking when starting a cycle. Upon arrival, found the fill hose hanging forward and disconnected from the case brake assembly on the side of the dishwasher. Pulled the dishwasher out, reconnected and properly secured the fill hose, and installed a clamp to help prevent it from coming loose again. Started a cycle and verified the dishwasher fills, circulates, and drains properly with no l


Samsung Dryer - Vibration Noise
Model: DVE45T3200W/A3 Location: Fort Myers, FL 33901 Repair Summary Checked dryer for a vibration noise during operation. Upon arrival, started a cycle and duplicated the vibration noise. Recorded before-and-after videos for documentation. Disassembled the dryer and found significant lint buildup throughout the unit, including around the blower wheel and lint filter area. Thoroughly cleaned the lint buildup, reassembled the dryer, and tested operation. The abnormal noise is n


Samsung Washer - Concern Over Operation
Model: WA47CG3500AVA4 Location: Cape Coral, FL 33991 Repair Summary Checked washer for customer complaint that the unit was not operating properly. Connected HASS and ran diagnostics, which showed several stored error codes primarily related to off-balance conditions. Tested all components and verified the washer fills, washes, drains, and spins properly. Removed the control panel and inspected the main control board, finding it clean with no signs of overheating, burning, or


GE Washer - Not Starting A Cycle
Model: GTW485ASW0WB Location: Immokalee, FL 34142 Repair Summary Checked washer for not starting a cycle. Upon arrival, connected diagnostics and ran a service report, which showed a lid lock error. Verified the main control board was supplying voltage to the lid lock and the lid was physically locking; however, the control was not properly recognizing communication from the lock assembly. Replaced the lid lock assembly and main control board together and programmed the new c


Samsung Dryer - No Heat
Model: DVE45T3200W/A3 Location: Fort Myers, FL 33913 Repair Summary Checked dryer for no heat. Upon arrival, verified proper incoming voltage. Disassembled the dryer and found the heating element and thermal cutout had failed. Replaced the heating element assembly and tested operation. Checked the household vent system and found extremely high static pressure, indicating a significant vent restriction. Made the customer aware that the dryer vent needs to be professionally cle


GE Wall Oven - Shattered Glass
Model: PTS7000SN5SS Location: Punta Gorda, FL 33955 Repair Summary Checked wall oven for shattered inner oven door glass. Upon arrival, confirmed the inner glass was broken. Replaced the inner door glass and carefully removed all remaining loose glass from around the door perimeter. Reassembled and reinstalled the oven door, then opened and closed it several times to verify it was properly secured to the hinges and operating correctly. Tested the oven after the repair and ver


Samsung Fridge - No Cool
Model: RF29BB860012AA Location: Ave Maria, FL 34142 Repair Summary Customer missed the scheduled appointment. Technician waited approximately 30 minutes and attempted to contact the customer several times by phone and text with no response. Returned to the residence approximately one hour later as a courtesy and checked the refrigerator for weak cooling. Upon inspection, both the freezer and fresh food sections were maintaining temperature. Connected HASS and ran a service di


Samsung Oven - Unresponsive Display
Model: NX60A6111SS/AA Location: Fort Myers, FL 33919 Repair Summary Checked oven for the display controls not responding properly. Upon arrival, recorded a video showing that when Bake was selected, the up and down arrow buttons were not responding. Replaced the parts provided for the repair and tested operation. The controls responded significantly better immediately after the repair; however, the light button was initially intermittent. After several minutes, the light butt


LG Range - Front Burners Not Regulating
Model: LREL6325F Location: Punta Gorda, FL 33950 Repair Summary Checked range for both front burners not operating properly. Upon inspection, found the left and right front burners would not cycle down and remained on high. Replaced both front burner control switches and tested operation, verifying both burners now regulate properly from high to low. Customer also expressed concern that the oven was not heating properly. Preheated the oven to 375°F and measured an internal te


Samsung Fridge - Misshapen Ice Spheres
Model: RF70F27SERAA Location: Fort Myers, FL 33908 Repair Summary Checked refrigerator for misshapen ice spheres. Upon arrival, found most of the ice spheres were only partially formed, with some having elongated necks caused by the ice maker dripping water onto the ice during formation. Connected HASS and ran the Weak Cooling and Overall Tests, with the refrigerator passing all checks. Replaced the ice maker and ran test mode, verifying it cycled and operated properly with n


KitchenAid Fridge - No Cool In Freezer
Model: KRFC704FPS06 Location: Fort Myers, FL 33908 Repair Summary Checked refrigerator for freezer not cooling properly. Upon arrival, measured the freezer temperature at approximately 36°F. Pulled the refrigerator out and found a piercing/tap valve had previously been installed on the compressor by another service company, indicating prior sealed-system work. Returned and replaced the filter drier and removed the existing piercing valve. Pressure tested all sealed-system con


GE Fridge - Lights & Display Issues
Model: GWE22JYMCFFS Location: LaBelle, FL 33935 Repair Summary Checked refrigerator for no interior lights and the tabletop display not working. Connected diagnostics and found stored sensor and door switch error codes. The refrigerator was incorrectly detecting the doors as closed even when all three compartments were open. Replaced the tabletop assembly, but the condition remained unchanged, confirming an additional control issue. Returned and replaced the main control boar


Samsung Washer - Off Balance Error Codes
Model: WA50R5200AW/US Location: Alva, FL 33920 Repair Summary Checked washer for repeated unbalanced error codes preventing the customer from completing cycles. Connected HASS and ran a service diagnostic report, which showed multiple stored UB error codes. Cleared the codes and tested all components, with all other functions operating properly. Inspected the suspension and found it had failed, allowing the basket assembly to bounce excessively with little to no tension. Advi
bottom of page